Posted: Wed Jan 30, 2013 7:49 pm
Yes (ive been told before anyway) there the same part numbers arent they on lings? Same as the rear arms for 2WS stuff 
Page 1 of 1
Posted: Thu Jan 31, 2013 12:33 pm
Hmm, i may be wrong then xD Im pretty sure they fit from 4th to 5th though.
Posted: Thu Jan 31, 2013 12:49 pm
Lewis are you refering to the info from another thread? http://www.ludegeneration.co.uk/chassis ... t5192.html I think you might be confused as 2WS and 4WS lower arms are interchangeable between cars of the same generation.
I dont know if the LCA's are interchangeable between generations.
I dont know if the LCA's are interchangeable between generations.
Posted: Thu Jan 31, 2013 1:17 pm
Yeah and No Merlin. Im so sure ive been told somewhere the LCA's can also be inter-swapped. Investigation is needed 
Posted: Mon Feb 04, 2013 9:40 pm
Yeah they look well different.. but im so sure they cross fit. I might be wrong! And they do look smaller though... I must get some 4th gen ones and try
Posted: Tue Feb 05, 2013 7:23 pm
I'd say yes.... as i'm in contact with Rich at PAW as i'm going Fully polybush soon.. and i have Dinos rear lower control arms already polybushed ready to go on my car, Rich never had a problem with it! and if I was wrong he'll Bitch slap me down!!!!! 
Posted: Wed Feb 06, 2013 9:03 am
Right then lets clear this one up seeing as though I had the call
4th gen and 5th gen rear LCAs are interchangable 100% and it also doesn't matter whether they are 2ws or 4ws - both will fit.
I'm glad you managed to answer your own question about one being straight and one being bent...that was close to being a
The reason you find that OEM part numbers are different (for the two arms) is because they are sold with the bushes installed - 5th gen have a modified inner bush (which actually is no improvement over the 4th gen), the actuall arms are the same.
5th gen inner OEM bushes are not available to buy seperately from Honda so you have to use 4th gen inner if you wanted to just replace the bush.
4th gen and 5th gen rear LCAs are interchangable 100% and it also doesn't matter whether they are 2ws or 4ws - both will fit.
I'm glad you managed to answer your own question about one being straight and one being bent...that was close to being a
The reason you find that OEM part numbers are different (for the two arms) is because they are sold with the bushes installed - 5th gen have a modified inner bush (which actually is no improvement over the 4th gen), the actuall arms are the same.
5th gen inner OEM bushes are not available to buy seperately from Honda so you have to use 4th gen inner if you wanted to just replace the bush.