Page 1 of 1
Better to swap both Rear Hubs?
Posted: Mon Jul 22, 2013 10:22 am
by Lovedoctor
My rear offside bearing is on its way out. Having just changed the caliper, disc and pads its annoying but hey ho! Is it an easy job to swap myself (did the caliper etc) and doesnt require a special tool outside of my Halfords set? Also is it worth changing both at the same time or change as needed?
Decisions decisions
Posted: Mon Jul 22, 2013 10:24 am
by honda-hardy
Change as needed
Posted: Mon Jul 22, 2013 10:56 am
by mercutio
at the least you will need a bearing puller as it comes off in one unit or you could get a secondhand hub then it just unbolts from the back of the upright
Posted: Mon Jul 22, 2013 11:46 am
by BigTom
Yeah you'll need a puller, I ended up paying to get it done - it's listed as an hour job.
Nothing to be saved by doing both together, just wait for the other one to go.
Posted: Mon Jul 22, 2013 12:06 pm
by Lovedoctor
Is the hub/bearings not bought as one unit? I was hoping it was a bolt off and swap jobbie
Posted: Mon Jul 22, 2013 5:24 pm
by mercutio
no the bearing goes on the stub axle which in turn bolts to the upright if you get a secondhand hub then you can just bolt the lot on