fixings
Four of them you have to screw into window frame. For fifth (first from right) you have to make small cut in door seal and only push it in.
The easiest way to pull the inside seal
Just grab it and pull to the top and front of the car at the same time. Then under it you will find this
There is four of them holes. Also you have to deinstall another seal which is under the frame. Basically between this frame and glass. It's a real pitta to put it back, but if I made it then you can do it as well
You have to install four of brackets like that
This was easy part. Now reinstall seals. This need some patient and take time. Don't use screwdriver as seals are quite easy to cut with it. I found wooden spatula was very handy. You can also use a bit of oil (even cooking one will be good) for easier installation.
Then you install fifth bracket. You have to measure where to put it in, then make one small vertical cut (stanley knife) and press it through the seal to its place. It's a bit tricky as it have to sit in glass frame under the seal and you can't see anything. Sorry no photo of this one
When you finally get there you can say job was done.
The last bit. You have to open the window and screw in wind deflector (4 screws each side)
Then you press small clip through wind deflector and fifth bracket. It goes here
Repeat on the other side
Can anyone please help me on how to fit them. I have even asked my master tech, hes been working on Hondas since the early 90's 
and hes never fitted a set 
