Page 1 of 1
Number plate size
Posted: Fri Apr 25, 2014 8:13 pm
by ADS1
Anyone happen to know the size of 4th gen jdm number plates, front and rear?
I need to get new plates tomorrow, and forgot to measure them, before i left my garage.
Cheers.
Tony.
Posted: Sat Apr 26, 2014 10:22 am
by Donald
Should be 330mm by 165mm.
US size is slightly smaller at 305mm by 152mm.
Disclaimer: I haven't got a 4G but those are import plate sizes so can't see why they wouldn't fit.
Posted: Sat Apr 26, 2014 11:03 am
by ADS1
Ok buddy, thanks. Saves me a 30 mile round trip to my garage to measure
Posted: Sun Apr 27, 2014 10:05 pm
by NafemanNathan
Yep, 330x165, but the front will hang over the edge of the JDM front plate mount if you're using one.
Unless you...
Posted: Mon Apr 28, 2014 2:23 pm
by ADS1
Yes, it will over hang at front. How did you go about cutting yours down?
Posted: Mon Apr 28, 2014 2:25 pm
by bb1boy
I'm pretty sure a US plate fits a JDM plate holder, perfectly ...oddly enough
Posted: Mon Apr 28, 2014 2:26 pm
by NafemanNathan
Just a straight edge and a Stanley (Irwin) knife. About 4 good scores and you can fold/snap it. Where it fold/snaps it leaves a white edge though, but you can get rid of it with a bit of wet'n'dry, or just knife it all the way.
Posted: Mon Apr 28, 2014 2:41 pm
by ADS1
Ok. Thanks.