Page 1 of 1
Removing 5G side repeaters.....
Posted: Tue Jan 29, 2013 8:19 am
by Nik_L
As above, how do you remove the side repeaters from the wings?? Is it just a case of getting something very flat behind them at 1 side, then popping it out, and sliding it along a bit then thats it oot??
Posted: Tue Jan 29, 2013 8:34 am
by Rocky
Small screwdriver to lever it out from the side. Put a cloth around the screwdriver so you dOnt damage the Paint
Posted: Tue Jan 29, 2013 8:43 am
by rob quilter
Rocky wrote:Small screwdriver to lever it out from the side. Put a cloth around the screwdriver so you dOnt damage the Paint
This. They just pop out, dead easy.
Posted: Tue Jan 29, 2013 9:50 am
by Nik_L
Cheers guys.
Got them off, didn't notice the little notch on the side for popping them off so as recommended, i just used a small screwdriver and they popped off.
Posted: Thu Jan 31, 2013 9:01 pm
by CARRisma
I remove mine every time I wax The Lude so I can wax the surface around the orifice which is usually covered up (only a few mm).
Posted: Thu Jan 31, 2013 9:13 pm
by RattyMcClelland
CARRisma wrote:I remove mine every time I wax The Lude so I can wax the surface around the orifice which is usually covered up (only a few mm).
This is a good idea. I removed mine and a slight bubble of rust has started, luckily i removed them to respray the panel.
A bit of wax will protect that gap.