Lude Generation

How do u get to the screws under the lights for the bumpers thanks

by removing the bumper first

^^^^This

2 screws in the wheel arch the captive plastic screws across the front 2 bolts on the tie bars to the slam panel. then remove the indicators use a ratchet and extension to remove the 2 bolts holding the bumper support bar that hide behind the indicators, then there is a nut just behind each headlight that needs removing. Finally the fixings to the undertray then pull the whole bumper forward it will come out with the nostrils

Its like fort nocks fs. ive got side screws and middel plastic ones out but there some under lights it seems and cant get them.

Ahhhh wtf fell wick still cant get it off im thinking does the fog light need to come out to get to the to bots holden the slam panel as cant get fogs out as screws out of then as bit rusted

Side bolt in wing off plastic ones and one at back of light and one in behind the indicator

There is a nut on the inside of the engine bay, it's a long bolt attached to the bumper bar which slides through.

There should be one underneath each headlight, you can get at it easily with a spanner.

Left it as run out of light. Can u take the indicator out from the front? Ill get a good look at it saturday as we are just wanting to swap lights to are track car and have bumper off the spare. That bumper is well held on any how lol

A design flaw of the 4th is that to get the bumper off you need to take the front indicators out. But the indicator screws are often rusted in place I have replaced my screws with a bolt and nut.

Once the bumper is off you can access the 4 bolts that hold the bumper beam to the chassis. Then you can undo the final two nuts in the engine bay.

The other way to do it is to remove the under tray as you can then get to the bumper bar bolts that way. But again the screws and crappy little clips are rusted in place, and there are lots of them.