Lude Generation

what the hells holding your bar on then, please tell me its not just the plastic screws on the bumper holding it up?

they are just standard 10mm ones iirc. the same as used all over the car. I dont think they would change that between gens.

If they are not there that could explain your bumer being off. I reckon you will have a good outcome from this if you replace

three i think one needs an extender.

I only noticed a negative difference low rev's in one of the ludes I have done it to but that one had other issues. otherwise the lost 1-2ftlb between 2 and 4k dont equal the general better response, smoother curve and easier top end. Horse's for courses though. Let me know what you think..

If you mean the 4 bolts that are accessed by removing the indicators, pretty sure they are M8's with a standard thread, I'll double check later when I'm in the garage.

So the only thing holding your bumper on was the two nuts under the headlights in the engine bay?

good man

nice one bro, it sounds lovely doesn't it? glad you like it after the hoses mertalated themselves I have one spare if you ever need