Srs light

mart609 · Post by **mart609** » Sun Jun 19, 2016 4:15 pm

Is there a how to or whatever on how to get rid or the srs light after fitting an aftermarket wheel?

Post by **rob quilter** » Mon Jun 20, 2016 12:47 am

Mine has the bulb taken out lol. You can put a resistor on the end of the airbag connector, so it still thinks the airbag is still connected.

It isn't an MOT issue having no bulb, not even an advisory.

mart609 · Post by **mart609** » Mon Jun 20, 2016 8:21 am

I didn't want to pull the bulb tbh.
I just wanted to put the resistor in.
Just wanted to know what resistor I needed and how to wire it up

mart609 · Post by **mart609** » Mon Jun 20, 2016 6:33 pm

The hub I ordered didn't.
So now I've ordered another one with an SRS delete integrated

mercutio · Post by **mercutio** » Tue Jun 21, 2016 9:45 pm

i think i asked that question back in the puk days someone posted up a part number for the Honda resistor

uberNoobZA · Post by **uberNoobZA** » Wed Jun 22, 2016 2:15 pm

This is the resistor I ordered (after some research) for my Gen 4 Lude. Not used it yet, as I went back to OEM steering wheel.

TE Connectivity FRN50S Series Axial Thin Film Resistor 2.2Ω ±5% 0.5W ±350ppm/°C

Once you have the resistor in, you will still have to reset the SRS light using the standard procedure for this (just google it)

mart609 · Post by **mart609** » Thu Jun 23, 2016 8:46 am

Well the new hub came. The resistor provided doesn't work. So that was a waste of extra cash as I've still gotta go buy a resistor

uberNoobZA · Post by **uberNoobZA** » Thu Jun 23, 2016 9:05 am

I assume you ordered a generic hub with srs delete resistor? If so, it's pretty much a shot in the dark on whether the resistor is the correct one for your car.

I have not used the resistors I listed, but I got them based off specs I found on another Prelude forum. This is the link to the article, which goes through the fitting of an aftermarket hub and wheel - http://www.preludepower.com/forums/show ... 441?page=1

Here is the SRS light reset procedure by the way - http://www.preludepower.com/forums/show ... p?t=255215

mart609 · Post by **mart609** » Fri Jun 24, 2016 9:26 am

I got a 2.2ohm 0.6w resistor from maplin yesterday and thats done the trick

uberNoobZA · Post by **uberNoobZA** » Fri Jun 24, 2016 9:36 am

mart609 wrote:I got a 2.2ohm 0.6w resistor from maplin yesterday and thats done the trick

Glad to hear.