Page 1 of 2
brake warning light & handbrake light.
Posted: Sat Apr 19, 2014 4:59 pm
by mart609
Had to remove the rear light clusters today to take my bumper off.
since I've put everything back together the brake warning & handbrake light on the dash have stayed on.
But both my brake lights are working....
Posted: Sat Apr 19, 2014 5:31 pm
by newkid
Fluid level being low can cause this.
Posted: Sat Apr 19, 2014 5:37 pm
by rob quilter
newkid wrote:Fluid level being low can cause this.
This.
It could just be a coincidence its happened at the same time you've taken your bumper off.
Posted: Sat Apr 19, 2014 5:41 pm
by mart609
Yeah, it was fine this morning tho...
Pretty sure its happened in the past and I've just jiggled the wires and fixed it lol
Posted: Mon Apr 21, 2014 10:35 pm
by mart609
Checked the fluid level today and its about 10mm above the min level. so I don't think thats the cause. I'll top in up just incase.
Any other Ideas? It's pissing me off now because its tripping my abs and 4ws lights too after a short drive.
So my dash is like a xmas tree
Posted: Mon Apr 21, 2014 10:38 pm
by indigolemon
I reckon one of your blown bulb sensors is gubbed. Try this and see if it cures it, will eliminate the sensors:
http://www.ludegeneration.co.uk/wiki/in ... ning_light
Posted: Mon Apr 21, 2014 10:43 pm
by mart609
See, I asked my mate at the garage the other day if it had bulb warning sensors... he said no it just works off voltage... cheers for that
Posted: Mon Apr 21, 2014 10:51 pm
by mart609
Ok trying to get my tiny little mind around that... It that little brown box the warning sensor?
Posted: Mon Apr 21, 2014 11:00 pm
by Gayno
Yep
Posted: Mon Apr 21, 2014 11:09 pm
by Thebusofwoe
Can I just ask, do all 4th gens have this sensor thing? They seem to go wrong a lot
