Page 1 of 1

4g headlight adjustment

Posted: Sun Mar 29, 2015 5:33 pm
by GJMHONDA2012
My prelude failed its mot on friday due to the drivers side headlight being completely off, the mot tester tried to adjust said I need to get it sorted other than getting another headlight is there anything else I can do to rectify the problem??

Posted: Sun Mar 29, 2015 6:55 pm
by prahunt
How off is it? Must of been quite something!!
Surely it's not just an incorrect fitment on the bulb?

Posted: Sun Mar 29, 2015 7:45 pm
by GJMHONDA2012
Its way off but was fine before went in for mot then tester adjusted then failed it the bulb is fitted correctly

Posted: Sun Mar 29, 2015 8:25 pm
by prahunt
What did they do to adjust it yen?
That's harsh of them to fail it if it's there fault

Posted: Sun Mar 29, 2015 8:30 pm
by GJMHONDA2012
To try and do it myself using the adjustment points on the headlights he done the passenger side light no bother so god knows why he couldn't do drivers side

Posted: Sun Mar 29, 2015 11:12 pm
by wurlycorner
There's not much to plsy with on adjusting the headlights so this sounds a bit odd.
The bulb might be fitted correctly, but is it wired up correctly? If the terminals are connected incorrectly, you get the main beam filament lit instead of the dipped.
Pull the bulbs out of both of them and compare which filmant is lit.

If that's ok, then try a different bulb in the dodgy side.

Posted: Sun Mar 29, 2015 11:37 pm
by GJMHONDA2012
wurlycorner wrote:There's not much to plsy with on adjusting the headlights so this sounds a bit odd.
The bulb might be fitted correctly, but is it wired up correctly? If the terminals are connected incorrectly, you get the main beam filament lit instead of the dipped.
Pull the bulbs out of both of them and compare which filmant is lit.

If that's ok, then try a different bulb in the dodgy side.
will do mate cheers

Posted: Mon Mar 30, 2015 9:15 am
by bb1boy
I might be totally off on this, but I think the adjuster screws have little balls on the end that pop into sockets inside the headlight and these can separate if you over-adjust it.. so maybe need to pop the adjuster screw back into its socket.. maybe