Page 1 of 1
4th Gen Front Fogs - Screw size to fit fascia to bracket
Posted: Thu Jun 25, 2015 3:50 pm
by arif_manji
Hello guys,
I have recently bought a pair of fog lamps for my 4th Gen that has really badly seized screws between the bracket and front fascia, so I need to remove them and get some new ones.
Can someone advise me which one I need and maybe where to get them from? I link would be great.
Cheers!
Posted: Thu Jun 25, 2015 5:34 pm
by vanzep
I have been working on a couple of sets of 4th Gen fog lights - i will have a look for you. I know i bought some screws to fit the plastic bezels on the front so i know the size of that - is that the screws that you are after?
Posted: Thu Jun 25, 2015 5:41 pm
by vanzep
if you follow this link it will show the screws sizes need to install the fog lights - along with quite a bit of other info which may prove usefull.
http://www.ludegeneration.co.uk/electri ... 15998.html
Posted: Thu Jun 25, 2015 7:45 pm
by arif_manji
Yes, there the ones I'm after bud.
Posted: Thu Jun 25, 2015 8:09 pm
by vanzep
The screws that hold the plastic bezels on are M4x12mm pozi pan head stainless steel.
You can get 4pcs of them for £0.99 delievered - just follow the link below
http://www.ebay.co.uk/itm/M4-4mm-A2-Sta ... 2577368bca
I have quite a few spare parts including a set of brand new replica covers if you need
Posted: Thu Jun 25, 2015 9:01 pm
by wurlycorner
vanzep wrote:The screws that hold the plastic bezels on are M4x12mm pozi pan head stainless steel.
The originals aren't stainless, that's the big problem!
they're a complete rhubarb
But yep, I've replaced them with stainless too.
(
maybe I'll get round to fitting them back on the car one day
)
Posted: Sat Jun 27, 2015 9:53 pm
by arif_manji
Perfect - cheers chaps!!
