Lude Generation

anyone done this? need to swap Will's. so far ive;
removed the two screws at the front of the unit below the bottom corners, also a single screw underneath and towards the back of the unit. ive pulled the whole assembly towards myself and felt the clips let go. but then it wont come any further.

according to this guide
http://www.preludeaustralia.com/forum/s ... Conversion
that's all i need to do.

am i missing something - not tugging (ooer!) hard enough? ...

Hammer

Two at front. One in middle underneath. Unclipped looms from underneath an it just pulls out after that.

Check the service manual. I missed a couple of screws before I looked at that, myself.