Lude Generation

can anyone explain how i read the codes? i know how to with the service connector but not sure how to read the flashes. cheers!!

long flashes indicate tens, short flashes are units

two long flashes and 3 short flashes - 23 for example

P13 CODES

1 O2A - Oxygen sensor #1
2 O2B - Oxygen sensor #2
3 MAP - manifold absolute pressure sensor
4 CKP - crank position sensor
5 MAP - manifold absolute pressure sensor
6 ECT - water temperature sensor
7 TPS - throttle position sensor
8 TDC - top dead centre sensor
9 CYP - cylinder sensor
10 IAT - intake air temperature sensor
12 EGR - exhaust gas recirculation lift valve
13 BARO - atmospheric pressure sensor
14 IAC (EACV) - idle air control valve
15 Ignition output signal
16 Fuel injectors
17 VSS - speed sensor
19 Automatic transmission lockup control valve
20 Electrical load detector
21 VTEC spool solenoid valve
22 VTEC pressure valve
23 Knock sensor
30 Automatic transmission A signal
31 Automatic transmission B signal
36 traction control found on JDM ecu's
41 Primary oxygen sensor heater
43 Fuel supply system
45 Fuel system too rich or lean
48 LAF - lean air fuel sensor
54 CKF - crank fluctuation sensor
58 TDC sensor #2
61 Primary oxygen sensor
63 Secondary oxygen sensor
65 Secondary oxygen sensor heater
71 random misfire cylinder 1
72 random misfire cylinder 2
73 random misfire cylinder 3
74 random misfire cylinder 4

wheres the abs codes and 4ws codes, i can find them lol

i THINK that 17 VSS - speed sensor is the abs but dont quote me on that, i dont have abs

as for 4ws, i have no idea mate, i dont have that either

lol my management light isnt on, its the abs and 4ws thats on lol

wait is this on your 4th or 5th? what ecu are u using?

try this for your 4ws


http://www.ludegeneration.co.uk/honda-p ... -t102.html

in my 5th, justa standard h22a5 ecu. not sure on the number

lol ok ignore my first few posts i thought it was your 4th

try the 4ws reset in the link above

also, post up what codes your getting from your ecu