Missing ODB11 Plug. Please help

kernow_lude · Post by **kernow_lude** » Sat Jul 07, 2012 2:02 pm

Hi,
I dont have an ODB11 plug.

this is on the right hand side of my console

This is on the left hand side of my console

It looks like Honda have fitted there own type of diagnostic plug
has anyone seen this before. if you have had service light put out, did you see if its a special loom or an adapter to plug into the Honda blue plug then into an OBD11.

Is it possible to splice on an odb11 plug?

I have a 5th gen 2.2 Auto.

Post by **Merlin** » Sat Jul 07, 2012 2:22 pm

In the bottom pic unclip the two wire blue plug. That is the one you are looking for

kernow_lude · Post by **kernow_lude** » Sat Jul 07, 2012 3:37 pm

Thanks
I am trying to connect a odb2 Bluetooth scan tool

this looks like to will do the job, BUT will car talk to the scan tool?

i then want it to connect to my Android phone running Torque pro
https://play.google.com/store/apps/deta ... rque&hl=en

Post by **Merlin** » Sat Jul 07, 2012 3:47 pm

Apparently the data link connector is the 3 pin right next to the service connector. I dont know if the car will like the scan tool or not, most of us use a paper clip and read the light codes.

Bio · Post by **Bio** » Sat Jul 07, 2012 5:14 pm

I was looking into this recently, apparently our UKDM cars don't have an OBD2 connector and instead use a 3-pin Honda specific data connector.
Only the USDM had a OBD2 connector.

Apparently. That's what I found googling it the other day anyway.

vti2003 · Post by **vti2003** » Sat Jul 07, 2012 5:44 pm

^^ This.

I have been into this in some depth. Even a 3 pin to OBDII adapter lead won't work unless you have specific software/hardware. A Normal OBDII scanner won't work.

As above USDM have it due to legislation over there. We don't

What you have above won't work. I tried it with some borrowed gear and no good.

ziyaan · Post by **ziyaan** » Sat Jul 07, 2012 9:37 pm

paperclip + service manual = educated

kernow_lude · Post by **kernow_lude** » Sun Jul 08, 2012 9:25 am

It is not paperclip to reset lights that i am after, it is two way communication to the ECU.
This will then be able to comunicate with my Android smart phone to use Toruqe Pro

vti2003 · Post by **vti2003** » Sun Jul 08, 2012 6:25 pm

It really can't be done.

I was hoping to do exactly what you are looking to do but I had no luck.

it "may" be possible if you are a whizz with electronics and can wire an additional power feed to your scan tool and get the coms protocols sorted out but it would be a lot of work just to get to a point where you could test it.

mercutio · Post by **mercutio** » Sun Jul 08, 2012 6:33 pm

get a loom from the US and retrofit it to your UK car might do the trick

Lude Generation

Missing ODB11 Plug. Please help

Missing ODB11 Plug. Please help

Re: Missing ODB11 Plug. Please help