Lude Generation

Posted: **Tue May 21, 2013 12:39 pm**

hi all, i have just collected a Kicker solobaric l5 12" 2 ohm sub in a box for £21 on ebay.

the sub is a dual coil 600w rms 1200 watt peak, 2 ohm sub.
the amp i was planning to run it with is a fli 450s bridgable 4 ohm amp.

what would be the outcome if i were to run the 4ohm amp on to the 2 ohm sub?

does any one have any ideas, should i get a different amp, any sugestions on amp?

got it cheap as chips, due to a very bad and incorrect searchable description

http://www.ebay.co.uk/itm/251274419614? ... 106wt_1171

Posted: **Tue May 21, 2013 12:51 pm**

I think you would need to bridge it.

Posted: **Tue May 21, 2013 1:13 pm**

The sub is dual voice coil 2 ohms. So if you run both voice coils in series and double the resistance and bridge off the amp thats a 4ohm load.

Posted: **Tue May 21, 2013 2:28 pm**

excellent, i have opened it up and both are linked. so im good to go then?

Posted: **Tue May 21, 2013 4:06 pm**

Are they linked up in series or parallel? You amp + to voice coil 1 + vc1- to vc2+, vc2- to amp -

Posted: **Tue May 21, 2013 5:10 pm**

I will have to check

Lude Generation

kicker solobaric sub and amp compatability.

kicker solobaric sub and amp compatability.