Page 1 of 1
Spoiler brake light/ lose high mount brake light?
Posted: Fri May 31, 2013 3:57 pm
by claymore68
Looking to install oem spoiler this weekend and wondered if its best to lose the high mount brake light or splice the wiring and keep both, any thoughts or advice.
Cheers
Posted: Fri May 31, 2013 4:04 pm
by indigolemon
Legally, you should only have one - I'd go with the spoiler light.
Posted: Fri May 31, 2013 4:12 pm
by claymore68
cool so remove the internal high mount...simples I hope !
Posted: Fri May 31, 2013 4:15 pm
by honda-hardy
Or make a panel that says prelude like on 4th gen. Or wire it up to vtec and have it say vtec
Posted: Fri May 31, 2013 4:22 pm
by claymore68
honda-hardy wrote:Or make a panel that says prelude like on 4th gen. Or wire it up to vtec and have it say vtec
Oh I wish ,wouldn't seem right without vtec under the bonnet
Soon though.
Posted: Fri May 31, 2013 4:31 pm
by Pushki
claymore68 wrote:cool so remove the internal high mount...simples I hope !
You may need to source a blanking bezel.
I think
@Carrisma came up with a solution IIRC.
Posted: Fri May 31, 2013 4:38 pm
by honda-hardy
Forgot oops
Posted: Fri May 31, 2013 8:08 pm
by CARRisma
Pushki wrote:claymore68 wrote:cool so remove the internal high mount...simples I hope !
You may need to source a blanking bezel.
I think @CARRisma came up with a solution IIRC.
Here ya go:
http://www.ludegeneration.co.uk/post35316.html
Posted: Tue Jun 04, 2013 2:41 am
by honda-hardy
here you go bud.
i went to the 5th gen braking in london and thought of you when i was there.
as i said in the pm, the tabs are broken but it does stick down ok with the velcro i added.
