Project X - Black 4th gen. Now fully stripped.

Post by **rob quilter** » Sun Feb 24, 2013 12:23 pm

Needs too much attention? It looks mint! What's wrong with it?

JDM-BB4 · Post by **JDM-BB4** » Sun Feb 24, 2013 12:27 pm

No probs Phil. The weatherstrip could do with some trim cleaner to bring it back to black but its not missing any rubber.
I think its been replaced in the past.
Hopefully it stays intact that way when I try to remove it.

I think the rear sub has an aftermarket speaker in it Graham. I will check it out.

I think they are just lightweight pulleys Alex, will need to go out and check the size and belt lengths.

JDM-BB4 · Post by **JDM-BB4** » Sun Feb 24, 2013 12:32 pm

rob quilter wrote:Needd too much attention? It looks mint! What's wrong with it?

Rust - Both rear arches, top of the A pillar, drivers door, front of the bonnet.
Not to mention the scuffs on a few of the panels. Probably over £1k of bodywork to a reasonable standard with no guarantees that the rust wouldn't return on the arches again.

Im guessing thats the reason nobody else was keen to buy it when it went up for sale last year.

Dbo · Post by **Dbo** » Sun Feb 24, 2013 2:03 pm

are the el dials from a ukdm facelift model or are they plug and play jdm manuel pre-facelift?
if they are jdm ones can i have dibs please?

JDM-BB4 · Post by **JDM-BB4** » Sun Feb 24, 2013 2:06 pm

@indigolemon the rear centre speaker has an Alpine SPE-6903 3 way coax 6x9 in it, not the pathetic OEM setup, if you still want it.

Drax has shown interest in the RRD sideskirts, rear bumper with RRD spats abd the FM short shifter.

Post by **indigolemon** » Sun Feb 24, 2013 2:08 pm

JDM-BB4 wrote:@indigolemon the rear centre speaker has an Alpine SPE-6903 3 way coax 6x9 in it, not the pathetic OEM setup, if you still want it.

Yeah Dave, I'm still up for it!

Post by **ddoubledanny** » Sun Feb 24, 2013 2:16 pm

If the spoon lip is for sale can I have dibs please

Post by **Drax** » Sun Feb 24, 2013 2:16 pm

JDM-BB4 wrote:@indigolemon the rear centre speaker has an Alpine SPE-6903 3 way coax 6x9 in it, not the pathetic OEM setup, if you still want it.

Drax has shown interest in the RRD sideskirts, rear bumper with RRD spats abd the FM short shifter.

cheers matey, still after the short shifter & pics of it please

but id like to drop my PUK dibs on the rear bumper with spat & the skirts, ive checked my bank balance and i can't justify spending the money atm

mercutio · Post by **mercutio** » Sun Feb 24, 2013 2:17 pm

dibs on the front bumper buddy

JDM-BB4 · Post by **JDM-BB4** » Sun Feb 24, 2013 2:21 pm

Dbo wrote:are the el dials from a ukdm facelift model or are they plug and play jdm manuel pre-facelift?
if they are jdm ones can i have dibs please?

@Dbo I think the dials are from a UKDM facelift otherwise they would read primarily in KMPH unless anyone else can confirm? Not sure if UK and JDM are interchangeable.

No problem @Drax