Drax's JUN Prelude: Papa Smurf edition

[Merlin]

Very cool

[fithotblonde]

That's all looking so good dude. I will have to Bob up at some point soon to have a proper butcher's

[GJMHONDA2012]

P1 engine removal

Finally made a start on removing the old engine. slow progress, but its something.
Removing an engine is a bit like making love to a beautiful woman.


First, you have to open her up nice and wide


Study your target before entering, you need to remember what goes where


Then go in balls deep, dont stop - just watch you dont do your back in


Any thick excess liquid you come across, be prepared to have to have plenty of rags to clean up

Where did u get the intake vent?

[RattyMcClelland]

Mfactory Helical

[damon]

Oh dan I can feel my balls pulsing just thinking about your engine

[Drax]

That's all looking so good dude. I will have to Bob up at some point soon to have a proper butcher's

no worries, just let me know when your thinking

Where did u get the intake vent?

ebay, a carbon fibre company on there make them. you can also get them from Demon Tweeks in plastic form

Oh dan I can feel my balls pulsing just thinking about your engine

that's just my hand tickling them..

[newkid]

Same as me. Much coolness

[GJMHONDA2012]

Cheers dude, ur build is awesome btw

[Drax]

well after numerous attempts to remove the power steering bolt... it's a bit mullered


tried an air gun ...nope, shoving long hard items in holes (giggedy!!) to stop it spinning then a breaker bar on the bolt.... nope; because its a cast pulley it just disintegrates, then tried it in a vice, still spun! then cut a section off then put it in the vice again so it couldn't spin...finally the bolt was coming loose and after a while realised the threads had obviously spun as it was spinning but not coming off

so, replacement p/s pump required

[Merlin]

It looks a right bugger!