Congratulations to vtecmec for winning May/June's Lude Of The Month, with his DIY Turbo BB1 build.

>>> Click Here For Profile <<<

Image

Oil

Engine/Gearbox questions and discussion
Post Reply
Shafy8807
Posts: 20
Joined: Sun May 19, 2019 9:12 am
My Generation: 5G

Oil

Post by Shafy8807 » Tue Aug 13, 2019 8:09 pm

Looking for some help I'm fitting a oil pressure gauge to a h22a the sender thread is 1/8 npt does anyone know what the thread the oil pressure switch is please so I can get a t peice tia

User avatar
RattyMcClelland
Moderator
Posts: 9191
Joined: Wed Aug 04, 2010 10:02 pm
My Generation: 5G
PSN GamerTag: RattyMcClelland
Location: Leicestershire
Been thanked: 181 times

Oil

Post by RattyMcClelland » Tue Aug 13, 2019 8:14 pm

Use a sandwich plate between the oil filter.
Image

User avatar
Merlin
Moderator
Posts: 12292
Joined: Fri Aug 06, 2010 9:04 am
My Generation: 5G
PSN GamerTag: Merlinbadman
Location: Edinburgh
Has thanked: 29 times
Been thanked: 190 times

Oil

Post by Merlin » Wed Aug 14, 2019 12:08 pm

I would (and did on my own car) use a standard 1/8 npt oil capillary line in the OEM oil pressure sensor hole (back of the block) even though its 1/8 bsp. Then place your pressure sensor up at the bulkhead on a rubber mount to isolate it from vibration. Do not attach the pressure sensor directly to the block as it may snap off. viewtopic.php?p=164776#p164776

The OEM oil pressure sensor is next to useless anyway.
Image
BA8......... BB4......... BB8.........The JDM Muscle Bus

Shafy8807
Posts: 20
Joined: Sun May 19, 2019 9:12 am
My Generation: 5G

Oil

Post by Shafy8807 » Wed Aug 14, 2019 4:03 pm

Cheers guys I've ordered a sandwich plate now dont suppose anyone could help aswell my vtec is very intermittent and throwing out alot of smoke have done a compression test and that's fine so trying to get the oil pressure tested anyone point me in the right direction if it isnt the oil pressure?

Post Reply

Return to “Engine / GearBox”