Refurbish A Rocker cover

Slashdotdash · Post by **Slashdotdash** » Tue Feb 21, 2012 3:14 pm

So ive done loads in the past so here goes a walkthrough

Remove the gasket, washers and rubber vaccum bung

Get yourself a tin of Nitormoors paint stripper and go to town

Takes two or three goes over

Slashdotdash · Post by **Slashdotdash** » Tue Feb 21, 2012 3:15 pm

more to come

Slashdotdash · Post by **Slashdotdash** » Wed Feb 29, 2012 11:31 pm

Stripped and started smothing off mould lines and top ridge, (LOTS of sanding!)

Slashdotdash · Post by **Slashdotdash** » Tue Mar 20, 2012 8:26 pm

ok so bit of an up date, been working away in liverpool and edinburgh last couple of weeks

So first off, i finnished sanding off the to ridge line and all the moulding marks all over the cover, i then filled and sanded a few low spots with Isopons Metalik filler, and here its masked up ready for the first coat of acid etch primer

I stole nath's idea for pennies to mask the washer holes

And heres the final coat of 3 acid etch primer coats

Next step will be a 400 grit flat back and 3 coats of Upol high build primer

A1ex · Post by **A1ex** » Tue Mar 20, 2012 8:31 pm

Does this mean the cover in your sign will be up for sale soon?

Slashdotdash · Post by **Slashdotdash** » Tue Mar 20, 2012 8:44 pm

unfortunately this was the cover

i could soon make one again tho