EL dials help

Dbo · Post by **Dbo** » Wed May 16, 2012 5:43 pm

anybody know how to fit facelift EL dials into a pre-facelift BB1?

wasted my time today taking my dash apart to find my clocks have 2 plugs and the el dials have 3.

i took these dials out of a jdm BB1 and have the converter box and cut the wires off so still have the plugs in place

but not a clue how to fit them and make them work

any help please!!

Post by **Ammo** » Wed May 16, 2012 5:47 pm

I just colour matched the wires and it all worked

mercutio · Post by **mercutio** » Wed May 16, 2012 6:06 pm

there is a how to on puk stan did it i dont know if it made it over here

Dbo · Post by **Dbo** » Wed May 16, 2012 6:14 pm

i have just been reading that

i am not swapping the whole loom over

have just been told only the 10 pin and the 6 pin on el clocks need to be colour coded to loom in place

keeping my fingers crossed

Dbo · Post by **Dbo** » Wed May 16, 2012 6:17 pm

Ammo wrote:I just colour matched the wires and it all worked

did you do a JDM BB1 pre-facelift manual to JDM facelift EL dials ?