cam end seal how to?

bristol_bb4 · Post by **bristol_bb4** » Mon Jun 04, 2012 6:02 pm

Did abit of searching and can't seem to find a decent how to! Is this a hard job? Mine is leaking like a cheap hooker!

NCCMUR · Post by **NCCMUR** » Mon Jun 04, 2012 6:03 pm

bible?

Post by **Lude-dude** » Mon Jun 04, 2012 6:06 pm

all you have to do is remove the rocker cover

if you do take off the rocker cover be careful with the bolts, they tend to snap

and then torque down when done in the right order (see the manual)

get the aftermarket one instead of the rubber honda seal

bristol_bb4 · Post by **bristol_bb4** » Mon Jun 04, 2012 6:15 pm

Hmm I've taken the rocker cover off twice to have a look at it and I just can't see how to do it? Does the cam retiner have to be removed?

The bible?! Jesus loved hondas too?

Post by **4thgenphil** » Mon Jun 04, 2012 6:24 pm

you have to take the cam retainer our, i think they all have to come out, in order, and torqued up again, in order!

its in the manual

bristol_bb4 · Post by **bristol_bb4** » Mon Jun 04, 2012 6:31 pm

Grrr I thought so! Don't have a damn torque wrench

Cheers mate

Post by **4thgenphil** » Mon Jun 04, 2012 6:45 pm

pretty important to torque them up

Duo · Post by **Duo** » Tue Jun 05, 2012 8:13 am

Dude you're not too far away and I have two wrenches that will do it if you want a lend or come up here sometime and do it, read the manual carefully though, it does say at the bottom of the page, after telling you how to unbolt and re-torque it that during undoing it you should only loosen 2 turns at a time in sequence

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Tue Jun 05, 2012 11:12 am

I've got a torque wrench bud you can borrow too - did you still need that O2 sensor?

Also have some printouts of the service manual if you wanna borrow the pages?

Or just bring it round and we'll do ours together - still not fitted mine.

bristol_bb4 · Post by **bristol_bb4** » Tue Jun 05, 2012 9:49 pm

Duo wrote:Dude you're not too far away and I have two wrenches that will do it if you want a lend or come up here sometime and do it, read the manual carefully though, it does say at the bottom of the page, after telling you how to unbolt and re-torque it that during undoing it you should only loosen 2 turns at a time in sequence

cheers for the offer mate i still need to pop up and see those rims! just not got the money to spend at the moment

nucleustylzlude wrote:I've got a torque wrench bud you can borrow too - did you still need that O2 sensor?

Also have some printouts of the service manual if you wanna borrow the pages?

Or just bring it round and we'll do ours together - still not fitted mine.

yes mr rob i do need that o2 sensor! i did try ringing you back a few times on friday but figured you must have been busy and didnt want to bug you

let me know when you fancy doing your seal and ill pop up fo' sho'

really dont know if i fancy tackling it by myself