Exhaust,manifold,downpipe,back boxes-pics added 26/3

Post by **vanzep** » Fri Mar 15, 2013 5:41 pm

Having a bit of a clear out of exhaust parts

4th gen/5th gen stainless centre sections 60cm dia

I should have the 4th gen back box that goes with these sections in the next day or two - and there is a 42cm decat pipe that goes with it - that would make it a catback system 60cm - near enough 2.5"

here is a pic of the back box on the car

4th gen 2" stainless steel system including back box.

Manifold and downpipe - excellent condition.

Back box and centre section

also a couple of other random items

4th gen front lower subframe - good condition.

4th gen jdm front bumper support bar

Parts are in Edinburgh -collection welcome or can post at cost.

Post by **vanzep** » Sun Mar 17, 2013 12:06 pm

open to offers as im not sure how much these parts are worth

japcarmaniac · Post by **japcarmaniac** » Sun Mar 17, 2013 1:22 pm

did you manage to get the other exhaust off?

Post by **vanzep** » Sun Mar 17, 2013 4:26 pm

no not yet - hope to have a look at that tomorrow - will let you know

Post by **vanzep** » Sun Mar 17, 2013 8:47 pm

sent u pm

tizzy · Post by **tizzy** » Tue Mar 19, 2013 6:16 pm

Apologies if this has already been asked but how much for a 4th mid section delivered (unless your local)

Post by **vanzep** » Tue Mar 19, 2013 6:35 pm

replied to your pm
Im in Edinburgh as stated in my profile and in the add

Post by **vanzep** » Thu Mar 21, 2013 10:16 pm

4th gen 2" stainless manifold downpipe and centre section - provisionally sold to @CrunchyAdams82

4th/5th 60mm (2.36") centre pipes and jap can and decat pipe - hopefully available next week - sorry for the delay in getting the back box off but its been bloody freezing out there

Post by **vanzep** » Tue Mar 26, 2013 2:45 pm

Managed to get some pics today during a brief sunny spell

4th gen jap can back box which can be converted to fit a 5th gen. There are also two centre sections and a decat pipe for this - so its full cat back stainless steel . Its a 60mm system so just under 2,5 inches diameter. You can see its mandrel bent with good welds and solid flanges

It will be loud

The decat pipe is 42cm long. Its all made to go together so id prefer to sell it as a whole system. Collection from Edinburgh.

some pics of the centre sections and decat pipe - these could do with a wire brush and polish to get it looking like the back box

Post by **vanzep** » Thu Mar 28, 2013 10:08 am

2" stainless manifold,downpipe and powerflow centre section - SOLD