Drive shaft part

[Ferdie]

Hee

Allready need a little part

I hope someone have it!

I lost 2 of mine on the highway i thing


When you cut open the rubber where the red arrow is inside of the Drive shaft are 3 bolts.. that go's over the shaft!
Those 3 i need ore 2





I don't think some one have it but i can try
thanks people!

Ferdie

[DaveyBa8]

those are bearings, driveshaft cup bearings, i have spare ones, but i need them lol

[JDM-BB4]

I have 3 of those driveshaft bearings.

Replied to you pm.

[Pushki]

Hee

[Dbo]

what is "Hee" is that Dutch or something

[cebul]

Make sure you messure them, I remember I have had an issue, when my drive shaft's rubber split, and all dust gos inside of there, do I try to repleaced shaft wiht thoe bearings but I left old caising - and that caising did not fit to new dhaft - and than i've realised they were diferent - probably slighly biger

[bb1boy]

And make sure you put them in the right way up, on my first attempt they went in upside down and when I drove off all the corners snapped off the bearings! The bearing edges are slightly angled - pay attention!

[Cutz]

And make sure you put them in the right way up, on my first attempt they went in upside down and when I drove off all the corners snapped off the bearings! The bearing edges are slightly angled - pay attention!

my mechanic did that to 3 of mine last night

[Merlin]

And make sure you put them in the right way up, on my first attempt they went in upside down and when I drove off all the corners snapped off the bearings! The bearing edges are slightly angled - pay attention!

my mechanic did that to 3 of mine last night

It is easy to do when you don't know the correct way. Mind you it is fairly obvious they are wrong when the driveshaft is unable to move up and down.

[Cutz]

I thought exactly the same merlin but these things happen.

Ive done it wrong myself before but realised but I loaded the shaft up.