Accord Type-R intake manifold

nitin_s1 · Post by **nitin_s1** » Tue May 07, 2013 8:12 pm

Accord Type-R (Euro-R) intake manifold. It's a single runner intake so would be a good upgrade for any other H22 engine which has the dual runners. With a good tune it will give you a nice BHP gain and also a lot of Torque. It comes with all the sensors, EGR, fuel rail, injectors, other sensors etc (you get everything in the picture). Not sure if you can use the ATR fuel rail on your Prelude's but do your own research.

As you can see from the pictures it's in a very good condition, I've tried to clean up all the dirty and oil. Only one clip of the sensor is broken but I don't think that would be a problem as you the plug will still fit the sensor any ways.

I had the piece of paper with my name on it when I was taking pictures of the Mugen bits but it flew up and I was too lazy to get another one. You can see the same paving from that pic and this pic so it's genuine.

Was going to put this in my Type-S but I rather upgrade my brakes at the moment then try to install this bad boy.

£150 (Pick up from Wembley)

I can look in to posting this if anyone is seriously interested.

Post by **Merlin** » Tue May 07, 2013 8:17 pm

You can courier that for £8

nitin_s1 · Post by **nitin_s1** » Tue May 07, 2013 8:42 pm

nitin_s1 · Post by **nitin_s1** » Sat May 11, 2013 6:00 pm

BUMP!!

£140 delivered!!

toyracer69 · Post by **toyracer69** » Sun May 12, 2013 8:07 pm

Do you EVER fit anything that you buy???

LewisH · Post by **LewisH** » Sun May 12, 2013 8:08 pm

handsomedanc · Post by **handsomedanc** » Sun May 12, 2013 8:19 pm

is this really an upgrade to the type s???

Post by **RattyMcClelland** » Sun May 12, 2013 8:23 pm

Its an upgrade to ANY H22 bar the a7 that already has one. With a tune. Type S uses the same intake mani as other preludes.

handsomedanc · Post by **handsomedanc** » Sun May 12, 2013 8:25 pm

i assume you can just swap the fuel rails over if the ATR one cant be re-used

Edson · Post by **Edson** » Sun May 12, 2013 8:27 pm

Would this be better than a Skunk2 Pro series intake ?