5 gen type-s engine

Red motegi · Post by **Red motegi** » Wed May 22, 2013 12:34 pm

Complete with gearbox, clutch, all fittings Inc dizzy, LSD, starter, loom, pipework for lsd, radiator with cooler for LSD, type-s ecu. etc, etc outstanding condition (otherwise I wouldn't of bought it for an engine swap that didn't happen)
70,000miles,
Plug in and play!!! Already palleted up ready for delivery,
Just drop in, connect loom , shaft,s, pipework, gear and clutch and away you go.

£950 or offers.

Post by **Merlin** » Wed May 22, 2013 12:43 pm

Is it the original Type-S gearbox or a different gearbox? Also a pic of the head stamp would be good to aid identification of the engine. The stamps are on the head in a few locations, it should read P5M?

mercutio · Post by **mercutio** » Wed May 22, 2013 12:52 pm

judging from the pic with the atts box attached to the engine/box I would say it is the type s box

nitin_s1 · Post by **nitin_s1** » Wed May 22, 2013 12:55 pm

ATTS is there!

Red motegi · Post by **Red motegi** » Wed May 22, 2013 4:08 pm

All standard type-s and all genuine, As far as I'm aware it would be very hard to put another gearbox on, because of the ATTS, if it was do-able I would of done it,,,, I wanted the engine for my motegi, unfortunately the cast of the bottom end of the engine has no mounts for the normal drive shaft support going to the passenger side, so instead of butchering a perfectly good engine I've decided to sell up and get the mrs a dc5.
I am open to offers here guys as I want it gone.

Post by **cebul** » Wed May 22, 2013 6:27 pm

Mate you are in wrong- you can put any gearbox to Type S engine mate. Shaft suport can by usse like on any other Prelude. You can not do it on other way- Type S box will not fit to any other engine as oil filter is relocated on Type S block to makeore room for Atts unit

mercutio · Post by **mercutio** » Wed May 22, 2013 6:33 pm

cebul wrote:Mate you are in wrong- you can put any gearbox to Type S engine mate. Shaft suport can by usse like on any other Prelude. You can not do it on other way- Type S box will not fit to any other engine as oil filter is relocated on Type S block to makeore room for Atts unit

yeah I thought that the yanks do it all the time

nitin_s1 · Post by **nitin_s1** » Wed May 22, 2013 6:40 pm

You can't put another gearbox on types engine. Unless you make adapter plates etc etc. as far as I know.

Red motegi · Post by **Red motegi** » Wed May 22, 2013 9:34 pm

Well anyway, it's the original gearbox, and it has ATTS, everything. In the pictures is included... Even the pallet.

LewisH · Post by **LewisH** » Wed May 22, 2013 9:45 pm

Well considering this is no good, unless you have a type s car (if i am correct) GLWTS

Lude Generation

5 gen type-s engine

5 gen type-s engine

Re: Odp: 5 gen type-s engine