Spoiler brake light/ lose high mount brake light?

claymore68 · Post by **claymore68** » Fri May 31, 2013 3:57 pm

Looking to install oem spoiler this weekend and wondered if its best to lose the high mount brake light or splice the wiring and keep both, any thoughts or advice.
Cheers

Post by **indigolemon** » Fri May 31, 2013 4:04 pm

Legally, you should only have one - I'd go with the spoiler light.

claymore68 · Post by **claymore68** » Fri May 31, 2013 4:12 pm

cool so remove the internal high mount...simples I hope !

The "S" express · Post by **honda-hardy** » Fri May 31, 2013 4:15 pm

Or make a panel that says prelude like on 4th gen. Or wire it up to vtec and have it say vtec

claymore68 · Post by **claymore68** » Fri May 31, 2013 4:22 pm

honda-hardy wrote:Or make a panel that says prelude like on 4th gen. Or wire it up to vtec and have it say vtec

Oh I wish ,wouldn't seem right without vtec under the bonnet

Soon though.

Post by **Pushki** » Fri May 31, 2013 4:31 pm

claymore68 wrote:cool so remove the internal high mount...simples I hope !

You may need to source a blanking bezel.
I think @Carrisma came up with a solution IIRC.

The "S" express · Post by **honda-hardy** » Fri May 31, 2013 4:38 pm

Forgot oops

CARRisma · Post by **CARRisma** » Fri May 31, 2013 8:08 pm

Pushki wrote:
claymore68 wrote:cool so remove the internal high mount...simples I hope !
You may need to source a blanking bezel.
I think @CARRisma came up with a solution IIRC.

Here ya go: http://www.ludegeneration.co.uk/post35316.html

The "S" express · Post by **honda-hardy** » Tue Jun 04, 2013 2:41 am

here you go bud.
i went to the 5th gen braking in london and thought of you when i was there.
as i said in the pm, the tabs are broken but it does stick down ok with the velcro i added.