Driveshafts - Type S vs Std

Mudgey · Post by **Mudgey** » Mon Jun 10, 2013 6:49 pm

Hello,

Does anybody have any information on the differences between the Type S driveshafts and the non ATTS equiped cars? I just found out recently they are different lengths? Does anybody have any end to end dimensions fully compressed or just the difference in lengths?

Cheers!

Post by **RattyMcClelland** » Mon Jun 10, 2013 6:58 pm

They are different. The left driveshaft is split into 2 with an intermeadiate drive shalf that penetrates the atts system side anal.
No point in dimensions as they are completely different to each other.

Mudgey · Post by **Mudgey** » Mon Jun 10, 2013 7:53 pm

There is no intermediate shaft on the cars with ATTS as that's where the ATTS sits, the non ATTS cars have an intermediate shaft but I have heard the outboard shafts are different in length and I need to find out the exact size differences.

Post by **RattyMcClelland** » Mon Jun 10, 2013 8:01 pm

Drivers side is the same but the passengers side where the ATTS is uses an intermediate shaft into the ATTS and tranny.

Post by **RattyMcClelland** » Mon Jun 10, 2013 8:03 pm

4th gen right: 507.9-512.9mm
4th gen left: 520.9-525.9mm
5th gen right ATTS: 497-497.5mm
5th gen left ATTS: 485-486mm
5th gen right no ATTS: 505-510mm
5th gen left no ATTS: 484-484.5mm

Mudgey · Post by **Mudgey** » Mon Jun 10, 2013 9:31 pm

That's awesome, which side does the left and right refer too?

The "S" express · Post by **honda-hardy** » Mon Jun 10, 2013 9:46 pm

um,,, left and right.

Mudgey · Post by **Mudgey** » Mon Jun 10, 2013 9:55 pm

Lol, as in looking from sat in the car or looking at the front of the car

Mudgey · Post by **Mudgey** » Mon Jun 10, 2013 9:55 pm

Lol, as in looking from sat in the car or looking at the front of the car

Mudgey · Post by **Mudgey** » Mon Jun 10, 2013 9:55 pm

Lol, as in looking from sat in the car or looking at the front of the car