bumper bar bolts

W1ggz · Post by **W1ggz** » Wed Jun 19, 2013 7:18 am

what the hells holding your bar on then, please tell me its not just the plastic screws on the bumper holding it up?

Post by **lewd lude lover** » Wed Jun 19, 2013 7:27 am

they are just standard 10mm ones iirc. the same as used all over the car. I dont think they would change that between gens.

If they are not there that could explain your bumer being off. I reckon you will have a good outcome from this if you replace

Post by **lewd lude lover** » Wed Jun 19, 2013 8:03 am

three i think

one needs an extender.

I only noticed a negative difference low rev's in one of the ludes I have done it to but that one had other issues. otherwise the lost 1-2ftlb between 2 and 4k dont equal the general better response, smoother curve and easier top end. Horse's for courses though. Let me know what you think..

Post by **Vtecmec** » Wed Jun 19, 2013 8:31 am

If you mean the 4 bolts that are accessed by removing the indicators, pretty sure they are M8's with a standard thread, I'll double check later when I'm in the garage.

Post by **Merlin** » Wed Jun 19, 2013 9:01 am

So the only thing holding your bumper on was the two nuts under the headlights in the engine bay?

Post by **lewd lude lover** » Wed Jun 19, 2013 10:58 am

good man

Post by **lewd lude lover** » Thu Jun 20, 2013 10:29 pm

nice one bro, it sounds lovely doesn't it? glad you like it after the hoses mertalated themselves

I have one spare if you ever need