advice and a few bits and bobs.

The "S" express · Post by **honda-hardy** » Sat Jun 07, 2014 10:02 pm

Firstly, I know the driveshafts on the type s are different to the standard shafts length wise, but are the inner c.v joints the same throughout the 2.2 manual range? i have noticed the inner joint on the near side of my type s is split and completely dry. it has a bit of a knocking in it too. so if they are interchangeable....

i need an inner c.v joint for my lude. left side/nearside. so @w1ggs do you have one from your lude that i am seeing tomorrow if they are the same? @rattymcclelland @nitin_s1 are they compatible?

also i have noticed the drop links on the front have play too, so any recommendations or sites ?

also front lower ball joints, all 4. where do i get these from. the s has 2 lower front ball joints, where as the standard lude only has 1. so again are these compatible and where have people bought these from?

Post by **RattyMcClelland** » Sat Jun 07, 2014 10:21 pm

I think the CV joints are the same.
As for the Type S suspension parts. Either USA or lings in the VTi-S section of the UK prelude.

Post by **Thebusofwoe** » Sat Jun 07, 2014 11:29 pm

Sam, if you want oem parts just give me some part numbers or ur reg/chassis number and I can see if I can get them any better with my discount

. Some parts are not much cop with discount tho

The "S" express · Post by **honda-hardy** » Sat Jun 07, 2014 11:39 pm

cheers chris.
items 3 and 4 perhaps?

http://www.lingshondaparts.com/honda_ca ... k_03=23317

ratty, would you say im right with these?

Post by **lewd lude lover** » Sat Jun 07, 2014 11:46 pm

blueprint make the type s droplinks mate. any motor factor should carry them on order.

Post by **Thebusofwoe** » Sat Jun 07, 2014 11:47 pm

No problem. I am pretty sure that the joint will come naked tho, as in you would need the boot and boot retainer too chap. It's then it gets expensive

Post by **RattyMcClelland** » Sat Jun 07, 2014 11:48 pm

honda-hardy wrote:cheers chris.
items 3 and 4 perhaps?

http://www.lingshondaparts.com/honda_ca ... k_03=23317

ratty, would you say im right with these?

Yep.

Post by **Thebusofwoe** » Sat Jun 07, 2014 11:49 pm

Make sure you go on chassis number too, as they are two different numbers

Post by **RattyMcClelland** » Sat Jun 07, 2014 11:49 pm

MUST READ

Post by **Thebusofwoe** » Sat Jun 07, 2014 11:52 pm

we'll there you go, all info there