Air Intake to Throttle body ideas!

[RattyMcClelland]

The JRSC relocates and angles the throttle body so the OEM intake will no longer fit.

I want to put my Type S intake back into the car.

This is what i have to deal with.





I have cut the OEM pipe and tried that was bit it wont work.

The Type S intake pip diamater is 83mm. The throttle body intake diamater is 76mm.

What can you pussypatrollers think off to get it connected?

Air ducting?

[mercutio]

yeah air ducting looks like the way to go

whats that below your intake?

[RattyMcClelland]

Mishimotot oil catch can. I relocated it down there to fit the type s intake back in.

[bb1boy]

Could someone with a pipe bender, bend and stretch a piece of stainless tubing to fit? An exhaust fabricator perhaps?

[RattyMcClelland]

Cant drive the car to a massive bender of exhausts and i need it running ASAP. CLutch change next week. THat will be interesting considering half the engine comes out to change it.

[nucleustylzlude]

There is a better answer = bigger TB!

[bb1boy]

Hmm, small shoebox with two strategically cut holes in then haha

Good luck on the clutch change though, does the JRSC installation hinder things like clutch swaps then?

[andypont]

If you can find some 76 mm hose that's only 3 - 3.5mm wall just put a short section of that onto the TB and then use 83mm over that up to your intake.

[JDM-BB4]

I got something like this for mine and cut it to length.

http://m.ebay.co.uk/itm/151311910730?nav=SEARCH

I found a uk seller though, so that sped up the delivery.

[mercutio]

samco will have some 45 degree bend silicon tubing