what does a bare H22 engine weigh and engine stand wanted

The "S" express · Post by **honda-hardy** » Tue Aug 12, 2014 2:12 am

what does a bare H22 engine weigh?
also looking for either a good second hand engine stand or recommendations for a new one please.

106pete · Post by **106pete** » Tue Aug 12, 2014 8:59 am

A bare h22 with no rods pistons or crank is still pretty heavy, I'd guess 35-40kg

I bought a Clark engine stand, does the job nicely but be aware it's not a easy job to get the engine on and off, it's pretty much a 3 man job.

Post by **Merlin** » Tue Aug 12, 2014 10:11 am

They weight a fair amount. I bought a cheapo Ebay special and it was fine. Like this one http://www.ebay.co.uk/itm/Engine-Gearbo ... 2c7db03dcf

The "S" express · Post by **honda-hardy** » Tue Aug 12, 2014 11:22 am

Will that be okay for an assembled engine complete from cam to sump?

106pete · Post by **106pete** » Tue Aug 12, 2014 11:39 am

450kg...... I should think that will hold

Post by **Drax** » Tue Aug 12, 2014 11:50 am

Merlin wrote:They weight a fair amount. I bought a cheapo Ebay special and it was fine. Like this one http://www.ebay.co.uk/itm/Engine-Gearbo ... 2c7db03dcf

that's pretty much the one I have as well, does the job just fine

farlow · Post by **farlow** » Tue Aug 12, 2014 12:10 pm

I have a Clarke 4 wheeled engine stand and although I haven't had my engine on it yet I plan on having a fully built H22 sat on it. I would imagine the three wheeled one would do but my garage floor is quite uneven and I wanted the extra stability.

Post by **Merlin** » Tue Aug 12, 2014 12:19 pm

honda-hardy wrote:Will that be okay for an assembled engine complete from cam to sump?

Yup I had my full engine on there. It was actually was the 3 wheel version. I was able to wheel it about the workshop with no problems.

'92 Si VTEC · Post by **jjmartin349571** » Tue Aug 12, 2014 12:37 pm

How did you find the balance of a 3 wheel stand?? I bought a 4 wheeler for extra stability but it's surprising how much the extra 'axle' at the front gets in the way (if you're as clumsy as I am

)

Post by **Merlin** » Tue Aug 12, 2014 12:41 pm

I found it to be fine. The workshop floor was fairly smooth.