Wanted...h22a crank

Post by **ek9sid** » Thu Oct 02, 2014 12:39 pm

Hi guys. So, finally got the motor in the air to sort out this crank pulley business and turns out the previous owner had attempted to weld the pulley on

so as a result, it I can't get rid of these sordid welds, I might need a new crank.

I had a look at the bin on my car and it says the engine should be a h22a8 but had a look on the engine and it just says h22a. So I'm presuming they're 2 different motors and it's had a replacement one put in for whatever reason.

As a result I'd like one for the h22a. Cash waiting

Post by **Drax** » Thu Oct 02, 2014 5:02 pm

i have a spare h22 bottom end with no pistons for sale for £50, or i could take the crank out for £30 instead - plus postage as well, i can get a quote for that if you wish

Post by **4thgenphil** » Thu Oct 02, 2014 5:43 pm

What size block is it drax? Can u measure the bores?

Post by **Drax** » Fri Oct 03, 2014 12:03 am

4thgenphil wrote:What size block is it drax? Can u measure the bores?

sure, will "tape measure" measurements be enough? otherwise ill need to borrow a digital measuring device

plus im guessing you require bore width?