Honda Prelude s a PITA!!! Grrrrrrrr!

Post by **Wayne2014** » Thu Dec 11, 2014 1:49 pm

Ok putting most bolts back on ...

And a new set of tools and very very small hands to get in here!

Post by **Wayne2014** » Thu Dec 11, 2014 1:52 pm

Cant wait to tackle replacing electric aerial - its already a PITA trying to get access to it with that metal struct in the way - PITA Grrrrrrrrr!

Post by **RattyMcClelland** » Thu Dec 11, 2014 2:50 pm

You have to remove the bolts from the firewall side too in the engine bay. Same with the pipes.

Post by **Wayne2014** » Thu Dec 11, 2014 2:54 pm

RattyMcClelland wrote:You have to remove the bolts from the firewall side too in the engine bay. Same with the pipes.

wot?!!!

Post by **Gayno** » Thu Dec 11, 2014 6:12 pm

There will be bolts in the engine bay holding the boxes in place.

Post by **Wayne2014** » Thu Dec 11, 2014 6:38 pm

Gayno wrote:There will be bolts in the engine bay holding the boxes in place.

Does it matter now?
Now that i just removing the blower (and not blower casing)?

Just need to find right tool for it now ..

Post by **Gayno** » Thu Dec 11, 2014 6:54 pm

Should just be a 10mm nut

prelude91 · Post by **prelude91** » Thu Dec 11, 2014 7:09 pm

and were there any leaves/ debris inside the blower or casing?

Post by **Wayne2014** » Thu Dec 11, 2014 7:16 pm

Gayno wrote:Should just be a 10mm nut

No nutter please!

Post by **Wayne2014** » Thu Dec 11, 2014 7:17 pm

prelude91 wrote:and were there any leaves/ debris inside the blower or casing?

Didnt have time, Mike!

Will see if have time or right tools 2moro!
Not sure if i need to undo the 4 BOLTS (bigger black casing)
Or the 3 small screws for the smaller inner black casing ...