5th Gen Rear Windscreen Bung

Post by **Howzit37** » Wed Jun 03, 2015 4:22 pm

Howdy all,

As above please.

Many thanks

Post by **Howzit37** » Wed Jun 03, 2015 4:46 pm

Just to clarify, this is for the wiper and not so I can turn my 5th gen in to some weird little van by replacing the entire rear windscreen with a bung of some sort.

Post by **Merlin** » Wed Jun 03, 2015 4:58 pm

Assuming the hole is the same as the one on the 4th gen it will be 30mm ish.

NafemanNathan wrote:
I measured the hole to confirm the 30mm for Nucleustylz. It was closer to 31mm, but that shouldn't matter...

http://www.ludegeneration.co.uk/post9541.html

Post by **Howzit37** » Wed Jun 03, 2015 10:05 pm

Thanks Merlin. I've had a look on eBay and had a search on Google but can't seem to find anything suitable.

Any idea where I can get one from?

mercutio · Post by **mercutio** » Wed Jun 03, 2015 10:10 pm

you can get them for the 4g so i dont think the 5g will be any bigger

Post by **RattyMcClelland** » Wed Jun 03, 2015 10:28 pm

I used that guide on my 5th gen. Fits fine.

Post by **Merlin** » Thu Jun 04, 2015 2:11 pm

@Howzit37 yeah finding the right ones on eBay is difficult. http://www.ebay.co.uk/sch/i.html?_odkw= ... 0&_sacat=0

This place does them - http://www.rosshandling.co.uk/plugs-grommets.asp

mercutio · Post by **mercutio** » Fri Jun 05, 2015 4:57 pm

i got one for the 4g it was a piece of plastic with a threaded bit that you screwed tight from the inside

bb1boy · Post by **bb1boy** » Thu Jun 18, 2015 9:31 pm

Lift up rear seats of pretty much any car (preferably not your own) and there will be plastic bungs here and there, find one that's close and silicone it in place if it's too loose.