SiR - Fixed

mart609 · Post by **mart609** » Sat Aug 01, 2015 3:00 pm

Had the wagon checked over earlier this week before it goes in for MOT.
both inner cv boots are split and my downpipe was blowing from several places.
So I went and got this.

mercutio · Post by **mercutio** » Sat Aug 01, 2015 3:35 pm

very nice where from?

mart609 · Post by **mart609** » Sat Aug 01, 2015 3:44 pm

@kawa

Post by **vanzep** » Sun Aug 02, 2015 9:27 am

good choice

mart609 · Post by **mart609** » Wed Aug 05, 2015 11:48 am

Made a start on the MOT prep last night

Low life problems

Two new inner CV boots.

Sorry about the phone pics. Just got a couple of snaps while we were in progress.

Post by **Merlin** » Wed Aug 05, 2015 11:56 am

I'm the same, cant get the 4th gen on ramps easily

Good luck with the MOT!

mart609 · Post by **mart609** » Thu Aug 06, 2015 10:11 am

So time to get the fujitsubo to fit the accord
As it was from a prelude and the section is longer we had to cut it down

before:

After:

Got the one end flared so we could slot the pipe into it.

then offered it up to put a tack weld on it

Welded up:

Neither me or my buddy are welders so obviously its not the best job in the world.
But it will do for the time being to get me through the MOT until I get a piece properly made up.

Bay shot of the manifold on

Bay looks better now with an aftermarket header in there.
Just need to give it a good clean now

Exhaust has a new slightly deeper note to it now aswell

mart609 · Post by **mart609** » Sat Aug 08, 2015 12:32 pm

MOT Today.

mercutio · Post by **mercutio** » Sat Aug 08, 2015 1:06 pm

Good Luck

mart609 · Post by **mart609** » Sat Aug 08, 2015 7:52 pm

Passed

Only advisory: service brake only just met efficiency

Lude Generation

SiR - Fixed

SiR - Fujitsubo

Re: SiR - Fujitsubo

SiR - MOT Prep

Re: SiR - Fujitsubo fudge

Re: Re: SiR - Fujitsubo fudge

Re: Re: SiR - Fujitsubo fudge