Apex lowering springs, rears only. 35mm drop. Fitted for only a very short time. Very good condition.£15 posted.
H22 crank pulley and bolt £10 posted.
Cambelt auto tensioner holding tool, holds tensioner compressed while fitting,£5 posted
Jdm flare holder£4 posted.
[URL=http://s613.photobucket.com/user/Tonysm ... 1.jpg.html]
[/URL]H22 blue print ignition leads, 7mm. Only done 5000 miles £12 posted.
Oxygen sensor socket. Draper, 3/8 drive. £4 posted.
S2000 oil fiter tool. £4 posted.
Bearing puller £5 posted.
Digital caliper £5 posted.
Nut splitter, jaw size is 19mm. £4 posted.
Neilsen antislip sockets, for removing damaged nuts and bolts. Sizes 8-19mm.Never used £8 posted
Flare nut spanner, i think that's what it's called, for brake lines £3 posted.
Stethoscope, with extension probe. For listening for engine noises. Or can be used to play doctors and nurses with the missus
This has never been used....For either purpose!!!!lol £3 posted
Dremel type tool, hardley used, comes with accessory pack £20 posted.
Multi meter, electrical tester, with leads, and crocodile clips, plus full instructions. £20 posted.
Another puller tool, this one can be assembled in different ways, depending on use.No assembly instructions, but it's pretty simple to do. £10 posted.
Seal puller tool.£6 posted.
Toolzone compression tester, never used, so not sure how good it is. Pretty cheap make.£5 posted.
H22 exhaust manifold gaskets x2, 1 is used, genuine honda. The other is from rock auto, manufactured by victor reinz. Never used, but is only single layer steel, as opposed to honda item, which is multi layer steel. Either one £2 posted.
H22 passenger side intermediate drive shaft. This is the part that goes from gearbox to centre bearing.£15 posted.
Parkside angle grinder. Takes 125mm cutting discs. Used only once for 10 mins by a neighbour, so virtually as new.£15 posted.
Dent puller/slide hammer. Hardley used, but 2 of the accessories have gone missing over the years.£10 posted.
