Replacement type-s air intake section

BrokenSpring · Post by **BrokenSpring** » Mon May 16, 2016 4:33 pm

CARRisma wrote:I've made some measurements. The inside diameter of the hose needs top be 72mm at the throttle body and 79mm at the other end (dynamic chamber end). This might complicate matters. I dunno how stretchy these silicone hoses are.

Honda-Hardy used 76mm diameter which worked for him.

Ah good work with the measurements. I've not had a chance to get at the car this week, should get some good time on sunday though.
Im thinking of getting the below hose and some high temp sealant for the work. The only thing that worries me is bits falling off inside

http://www.ebay.co.uk/itm/300462081088? ... EBIDX%3AIT
http://www.ebay.co.uk/itm/221917898068

weegarry41 · Post by **weegarry41** » Mon May 16, 2016 6:48 pm

I have a complete standard 2.0l system sitting in the garage...

CARRisma · Post by **CARRisma** » Mon May 16, 2016 6:56 pm

BrokenSpring wrote:
CARRisma wrote:I've made some measurements. The inside diameter of the hose needs top be 72mm at the throttle body and 79mm at the other end (dynamic chamber end). This might complicate matters. I dunno how stretchy these silicone hoses are.

Honda-Hardy used 76mm diameter which worked for him.
Ah good work with the measurements. I've not had a chance to get at the car this week, should get some good time on sunday though.
Im thinking of getting the below hose and some high temp sealant for the work. The only thing that worries me is bits falling off inside

http://www.ebay.co.uk/itm/300462081088? ... EBIDX%3AIT
http://www.ebay.co.uk/itm/221917898068

Bear in mind that hose in the link is 45 degrees bend where Honda-Hardy suggests 60 degrees would be better.

CARRisma · Post by **CARRisma** » Sun Nov 20, 2016 4:45 pm

Further info:

http://www.ludegeneration.co.uk/topic19856.html