ebay exhaust manifolds

secla · Post by **secla** » Wed Apr 25, 2012 5:20 pm

Average, bad or really bad.
Not really to interested in performance but my stock one is falli.g to bits. Anyone have any experience.

Post by **Merlin** » Wed Apr 25, 2012 5:21 pm

Cheap replacement for the OEM manifold. I had one on my old 97 5G.

JayJay · Post by **JayJay** » Wed Apr 25, 2012 5:25 pm

Nothing special, just as Merlin said a cheap replacement. I've actually got one for sale, already heat wrapped (the OEM heat shield doesn't mount on the eBay ones).

Post by **rob quilter** » Wed Apr 25, 2012 5:38 pm

Don't expect any power gains, but as said - its a fine for OEM replacement.

secla · Post by **secla** » Wed Apr 25, 2012 6:07 pm

So are96-98 manifolds the same fit as 4th gen 92-95 ?

Post by **Donald** » Wed Apr 25, 2012 6:23 pm

I would have thought they would be different unless it's the H22A engine, which AFAIK is the only common engine between the two generations? No doubt someone will come along and let you know for sure though.

Merlin is the wizard you need to talk to about exhausts, he seems to know loads about JDM, UKDM, A5 & A8 compatibility etc.

Post by **Vtecmec** » Thu Apr 26, 2012 12:00 am

I've had a bad experience, the supporting bracket snapped within weeks and needed repair, it lasted for about 3 years total, after plenty of ongoing repairs, and by the end it had crumbled and rotted to nothing. Yes it was stainless, but they still rot, and heat wrapping them means that water sits on it and accelerates the corrosion. There are pics in my project thread in my signature somewhere.

OK for a temporary stop gap, but nothing more.

littlefeller · Post by **littlefeller** » Thu Apr 26, 2012 12:03 am

be careful, some are a larger diameter than stock which sugests more flow, however without the head flowed you will end up loosing power with a larger mani

Post by **Merlin** » Thu Apr 26, 2012 9:11 am

Vtecmec wrote:I've had a bad experience, the supporting bracket snapped within weeks and needed repair,

I couldnt get my supporting bracket to connect up so I just left it, it never did any harm.

Supercharged 無限MUGEN BB1 Profile · Post by **nucleustylzlude** » Thu Apr 26, 2012 10:05 am

Unless it's a UKDM 4th gen which is slightly smaller diameter design to the JDM's.

Most ebay copies out there are the old DC sports design copies, which will see a small gain over the OEM on UKDM's. But generally are cheaper than buying a replacement if you have a leak or broken flexy. Some have problems with the bracket as mentioned, others have found the welds to be weak and crack over time.

If you're really after power gains, you need to spend some more dough I'm afraid. My first port of call would be Alan at Solid Fabs to make you a custom one. There are nice brands out there like Fujitsubo, Mugen, Tanabe, etc, but finding one and the cost means Alan would be the best bet personally. I know I have one, he's got the skills!

Cheers,

Rob