Congratulations to vtecmec for winning May/June's Lude Of The Month, with his DIY Turbo BB1 build.
>>> Click Here For Profile <<<

>>> Click Here For Profile <<<

Only one front fog light working
- James 5th gen
- Posts: 201
- Joined: Thu Sep 29, 2016 10:43 pm
- My Generation: 5G
- Been thanked: 4 times
Only one front fog light working
Any ideas on this? The wire connections are good because I’ve redone today thinking that was the problem. Still not working though, the left one is the culprit (sitting in the car) the bulb also is still all together and hasn’t been turn on since I bought it
-
- Posts: 1407
- Joined: Sat Aug 31, 2013 4:44 pm
- My Generation: 5G
- Location: Didcot
- Has thanked: 21 times
- Been thanked: 263 times
Re: Only one front fog light working
On my 5th gen JDM fogs, the connections were quite unsatisfactory.
Firstly where the bulb meets the housing, I had to use a dremel to clean up the seat where the bulb sat. It flat out refused to conduct.
Secondly, the earth terminal was bad in the same way. Had the clean up both with a dremel (under the screw).
Also, my bulb retainer clip wasn't very secure. Check it before fitting the fogs because it's a pain to check them afterwards, mine kept popping off. I suspect a little filing would make the recess/grove more secure.
Sent from my MIX using Tapatalk
Firstly where the bulb meets the housing, I had to use a dremel to clean up the seat where the bulb sat. It flat out refused to conduct.
Secondly, the earth terminal was bad in the same way. Had the clean up both with a dremel (under the screw).
Also, my bulb retainer clip wasn't very secure. Check it before fitting the fogs because it's a pain to check them afterwards, mine kept popping off. I suspect a little filing would make the recess/grove more secure.
Sent from my MIX using Tapatalk
'00 UKDM 2.2VTI H22a8
'21 'e' Advance
'21 'e' Advance