CF bonnet spoiler - mould finish :) & damaged :(

A1ex · Post by **A1ex** » Fri Jul 20, 2012 10:04 pm

Spent 4 hours tonight playing with kids clay. Not as fun as it sounds but it left me with this;

You may be wonder why I've done this, well, it's so when I put the tooling get on tomorrow I can run it down to the table surface and give it a flat edge all the way around.

You may still be wonder why I've done this. It's to give a good even surface to seal the vacuum bag against with some space on either side of the part for the vacuum connector and the resin infusion spiral

So the bonnet spoiler will be the first resin infused part off the production line.

Those of you thinking are you going to finish any of these parts?

I'm going to re-mould the mugen spoiler with tooling gel and the same flat over flow edges so this can be infused tool, not happy with the either of the glass moulds I've made.

There will be more pics to follow tomorrow

Post by **Vtecmec** » Fri Jul 20, 2012 10:05 pm

Post by **rob quilter** » Fri Jul 20, 2012 10:15 pm

Shaweeeet!

mercutio · Post by **mercutio** » Fri Jul 20, 2012 10:21 pm

very cool

A1ex · Post by **A1ex** » Fri Jul 20, 2012 10:22 pm

mercutio wrote:very cool

Thought your comment woukd have been 'about bloody time'

mercutio · Post by **mercutio** » Fri Jul 20, 2012 10:24 pm

was being positive and constructive

nitin_s1 · Post by **nitin_s1** » Fri Jul 20, 2012 10:50 pm

Now everyone will have one, it was meant to be rare.

Post by **Donald** » Fri Jul 20, 2012 10:55 pm

S-spec spoiler will be next Nitin!

nitin_s1 · Post by **nitin_s1** » Fri Jul 20, 2012 10:57 pm

Gorgon wrote: S-spec spoiler will be next Nitin!

I'm selling my car.

mercutio · Post by **mercutio** » Fri Jul 20, 2012 10:58 pm

nitin_s1 wrote:
Gorgon wrote: S-spec spoiler will be next Nitin!
I'm selling my car.

before you crash it