Adjustable camber UCA mounts

106pete · Post by **106pete** » Tue Sep 18, 2012 8:22 pm

The front ones with the expensive ball joints fitted? In that case noo

Post by **4thgenphil** » Tue Sep 18, 2012 9:09 pm

106pete wrote:The front ones with the expensive ball joints fitted? In that case noo

nah i was on about the ones with the cheap ball joints fitted

JDM-BB4 · Post by **JDM-BB4** » Tue Sep 18, 2012 9:51 pm

I had no issues with these on my car and it was pretty low.
I think the ball joint type are more likely to foul the strut tower as the adjustment is above the arm.

You've done the right thing marking them once set so you'll know if they have been knocked out.

Post by **4thgenphil** » Tue Sep 18, 2012 9:53 pm

did i buy them from you? i cant remember

JDM-BB4 · Post by **JDM-BB4** » Tue Sep 18, 2012 10:42 pm

Maybe, neither can I!

Post by **4thgenphil** » Tue Sep 18, 2012 10:44 pm

JDM-BB4 wrote:Maybe, neither can I!

did you sell 2 sets at different times? if so then yes!

vtectom · Post by **vtectom** » Tue Sep 18, 2012 11:49 pm

I need to increase front camber on my track-car - will these work both ways (increase & decrease)??

Post by **cebul** » Wed Sep 19, 2012 2:54 pm

Could you explain to me (show on the picture) how to fit them, because I can not magine this.

I've seen adjustable ball joint fitted in wishbone arm but do not know where these ones going??

mercutio · Post by **mercutio** » Wed Sep 19, 2012 3:06 pm

they go between the wishbone and the chassis the square part goes into the fork ends of the wishbone and the threaded part goes through the inner wing and is bolted up

Post by **4thgenphil** » Wed Sep 19, 2012 3:10 pm

cebul wrote:Could you explain to me (show on the picture) how to fit them, because I can not magine this.

I've seen adjustable ball joint fitted in wishbone arm but do not know where these ones going??

These won't work on the front of a 5th! Should do on the back though!

Lude Generation

Adjustable camber UCA mounts

Re: Adjustable camber UCA mounts