H22 polo first start help..

Danni22 · Post by **Danni22** » Sat Dec 22, 2012 1:55 pm

Thanks buddy...

They all look the same toe and iv not a clue lol all are for the ignition.

I have installed the whole loom, iv only removed the
abs,
4ws,
electric windows,
Heater wiring,
And carbon canister
And I couldn't get the ignition switch as it was fixed into the barrel

I no the reason it's not starting I's due to the auto wiring and inhibitor switch mod i need to do mod the clutch lockout also I need to wire in the push start fully,

Post by **vanzep** » Sat Dec 22, 2012 4:46 pm

sounds like your on the way to getting it fixed thanks to the help from the guys on the forum - dont forget to rep them

it would be great to see this engine fired up before xmas day

Danni22 · Post by **Danni22** » Sat Dec 22, 2012 5:03 pm

I don't think I could if do e it without the advice of you lads

..!! I'll rep away

..

Should be fired up tomorrow, iv got 2 of my mates coming at 9 to crack on giving me a hand and get it going

Post by **vanzep** » Sat Dec 22, 2012 5:15 pm

good news mate - fingers crossed

Danni22 · Post by **Danni22** » Sat Dec 22, 2012 10:29 pm

Ok soooo iv got this,

http://i705.photobucket.com/albums/ww60 ... 5E00A1.mp4
She turns over, but no spark or fuel pump prime I'm guessing its not an immobiliser issue as it would start and cut out..

Anyone have any clues.. I'm not so worried about the fuel pump as o can wire that into a switch its more the no spark

Edit;

Iv grounded the blue starter relay / immobiliser wire so it should fire up, do I need to do the ECU mod to get a spark?? As iv got no engine check light so I'm guessing I'm getting no signal from the ecu

mercutio · Post by **mercutio** » Sat Dec 22, 2012 11:30 pm

which gen do you have the ecu from and was it jdm or uk

Danni22 · Post by **Danni22** » Sat Dec 22, 2012 11:44 pm

Uk 5th gen buddy

Post by **RattyMcClelland** » Sun Dec 23, 2012 12:53 am

Immobilizer wouldn't ignite but would turn over on the starter.

Danni22 · Post by **Danni22** » Sun Dec 23, 2012 1:06 am

The key is in the ring so it should pick that up iv also grounded the blue starter / immobiliser wire as seen in this guide..
http://www.preludepower.com/forums/show ... p?t=302157

I'm thinking I could of plugged the engine harness/ecu harness in wrong or can the plugs only go into certain ones??

Tomorrow I'm going to re do all the earths, loose check plugs / wires

One question the fuel relay that's the one with the ball in it that cuts out if upside down..?? I'd so do I need to push it in until it clicks to get it to work?

Danni22 · Post by **Danni22** » Sun Dec 23, 2012 10:39 am

This is the only connector NOT connected

Wiring colours are;
Green/black trace
White
Black
Green/red trace
Blue/white trace