rocker bolt

Post by **Ammo** » Tue Nov 06, 2012 12:54 pm

10Nm they should be torqued to, so not much at all

h10ndr · Post by **h10ndr** » Tue Nov 06, 2012 1:04 pm

You only use dabs of sealant on the 4 corners where the gasket is shaped to loop over the cam holders. This is to help seal the corners and prevent leak. Its a tiny dab needed. Not enough to squeeze outside the gasket ideally.

spudep91 · Post by **spudep91** » Tue Nov 06, 2012 3:38 pm

Can i reuse the gasket on it?

mercutio · Post by **mercutio** » Tue Nov 06, 2012 9:34 pm

spudep91 wrote:Can i reuse the gasket on it?

depends on the condition they are cheap enough though so better to replace