Removing 5G side repeaters.....

Nik_L · Post by **Nik_L** » Tue Jan 29, 2013 8:19 am

As above, how do you remove the side repeaters from the wings?? Is it just a case of getting something very flat behind them at 1 side, then popping it out, and sliding it along a bit then thats it oot??

Rocky · Post by **Rocky** » Tue Jan 29, 2013 8:34 am

Small screwdriver to lever it out from the side. Put a cloth around the screwdriver so you dOnt damage the Paint

Post by **rob quilter** » Tue Jan 29, 2013 8:43 am

Rocky wrote:Small screwdriver to lever it out from the side. Put a cloth around the screwdriver so you dOnt damage the Paint

This. They just pop out, dead easy.

Nik_L · Post by **Nik_L** » Tue Jan 29, 2013 9:50 am

Cheers guys.

Got them off, didn't notice the little notch on the side for popping them off so as recommended, i just used a small screwdriver and they popped off.

CARRisma · Post by **CARRisma** » Thu Jan 31, 2013 9:01 pm

I remove mine every time I wax The Lude so I can wax the surface around the orifice which is usually covered up (only a few mm).

Post by **RattyMcClelland** » Thu Jan 31, 2013 9:13 pm

CARRisma wrote:I remove mine every time I wax The Lude so I can wax the surface around the orifice which is usually covered up (only a few mm).

This is a good idea. I removed mine and a slight bubble of rust has started, luckily i removed them to respray the panel.
A bit of wax will protect that gap.