Suggestions for wheel nuts...

Post by **Lude-dude** » Fri Feb 22, 2013 1:18 pm

was gonna say... some powder coated nuts might last longer

Post by **NafemanNathan** » Mon Mar 04, 2013 5:18 pm

stk prelude wrote:well show a pic ... lets see what they're like now...Merlin/Nathan good feed back for people who spending a lot of money on them...

Had a bit of a session with these over the weekend. As said, they weren't looking too hot...

This was the worst one...

But after a good 5 minutes per nut with the wet'n'dry in the kitchen sink, all seemed not that bad after all. I wrote the worst one off as that was too far gone and a second one I didn't bother with too much either...

But the rest!

...

And not to worry that I was now two short... I'd bought a pack of twenty

...

Still blatantly need to stay on top of them though

I was thinking about treating them will a light oil or silicone spray.

macky_6 · Post by **macky_6** » Mon Mar 04, 2013 8:02 pm

They came up pretty well