what goes into the hole

spudep91 · Post by **spudep91** » Thu Nov 08, 2012 12:52 pm

[insta]http://instagr.am/p/RxObomkuNE/[/insta]

spudep91 · Post by **spudep91** » Thu Nov 08, 2012 12:53 pm

Can i just plug that hole up thanks

nitin_s1 · Post by **nitin_s1** » Thu Nov 08, 2012 12:55 pm

Block that hole.

spudep91 · Post by **spudep91** » Thu Nov 08, 2012 12:58 pm

Post by **NafemanNathan** » Thu Nov 08, 2012 1:39 pm

Wrong question to be asking on this forum

You've already got one breather hose connecting the induction pipe to the valve cover, so that one isn't necessary.

Love the purple anodizing on your injector resistor box by the way

Post by **indigolemon** » Thu Nov 08, 2012 1:40 pm

That hole is for the H23, not needed for your engine.

h10ndr · Post by **h10ndr** » Thu Nov 08, 2012 2:12 pm

Its normally smaller than that on most intakes. That hole IS in use on a UK H22A motor. Its not needed for the JDM H22A. It connects to a small pipe which is suspended over the intake manifold. Its something to do with idle though as I found out. Without it connected the revs didn't drop when off the throttle, when changing gears.

Shiny · Post by **Shiny** » Thu Nov 08, 2012 3:57 pm

PTFE Tape & a screw, job done.