How much to sleeve an H22?

Post by **NafemanNathan** » Wed Aug 13, 2014 12:24 pm

Anyone got a good idea/experience of how much I should be paying an engine builder to sleeve an h22?

It'd be to standard bore (more than likely), but I'm considering custom pistons and it'll give me a lot more options if I can go forged.

@ddoubledanny, you didn't get your quote itemised by chance did you?

Post by **RattyMcClelland** » Wed Aug 13, 2014 12:51 pm

It would be around 1k including custom sleeves. I'm exploring this route with darton mid wetters.

My bro in laws garage rebuilt a focus st and the engine block got machined, bored and resleeved at graham Goode for just over 1k.

Post by **NafemanNathan** » Wed Aug 13, 2014 1:14 pm

Kind of the ball park I imagined. Cheers Scott.

Post by **ddoubledanny** » Wed Aug 13, 2014 2:34 pm

I've gone for Darton mid wet sleeves all in with machine work was £1200

Post by **NafemanNathan** » Wed Aug 13, 2014 2:37 pm

Cheers Dan

106pete · Post by **106pete** » Wed Aug 13, 2014 3:35 pm

Have u seen the guy breaking a atr turbo on Facebook? It just states a forged bottom end, maybe some use to you?

Post by **NafemanNathan** » Wed Aug 13, 2014 3:45 pm

Ooo, got a link?

106pete · Post by **106pete** » Wed Aug 13, 2014 4:54 pm

It's on HONDA PARTS FOR SALE the guys called jay kullar

I'm not sure if it's been removed as I can't find it now but maybe just pm him over Facebook

Post by **NafemanNathan** » Wed Aug 13, 2014 5:12 pm

Cheers Pete. I've just sent my request to join.

Post by **RattyMcClelland** » Wed Aug 13, 2014 7:01 pm

ddoubledanny wrote:I've gone for Darton mid wet sleeves all in with machine work was £1200

Who did/or is doing the work?