Oil Pressure Switch

Post by **NafemanNathan** » Sat Oct 27, 2012 7:14 pm

Vtecmec wrote:
NafemanNathan wrote:What, the one I've just bought is the same connection as your new one?

It's literally just below the oil filter.
No, sorry,the ebay link is the one I have, I'll check it tomorrow.

Ahh gotcha. Cheers bud

Post by **Vtecmec** » Sun Oct 28, 2012 7:56 pm

I had a brief look today. The connection was the philips screw type, ideally I would have checked the thread for fitment, but not wanting a face full of oil I left it alone. I'm pretty confident that the intermotor part is the right one.

Ted · Post by **Ted** » Sun Oct 28, 2012 8:01 pm

why dont you just nick the one out of superlude and put in bangerlude to try, if all is ok then stick the new one in on a spade. if all is not okay i will be over to buy bangerlude for £200 on tuesday morning at 7.00am sharp

Post by **vanzep** » Sun Oct 28, 2012 8:15 pm

ive got a spare here that i can measure up for you Nafe
its a unipart one i got of the bay a while back - not got round to fitting it.

Post by **Vtecmec** » Sun Oct 28, 2012 8:20 pm

Looks the same as mine.

Post by **NafemanNathan** » Sun Oct 28, 2012 8:59 pm

tramroadmotors wrote:why dont you just nick the one out of superlude and put in bangerlude to try, if all is ok then stick the new one in on a spade. if all is not okay i will be over to buy bangerlude for £200 on tuesday morning at 7.00am sharp

I didn't want to disturb the superlude (

) I was pretty confident I just have the wrong type of connector from MotorFactors and that I just need the style as Vtecmec and Vanzep have shown below... I just wanted to double check as the part number for the BluePrint does seem correct.

Mind you, Vanzep's lude is an import and so is Vtecmec's right?... So this still hasn't shown whether or not it's the difference between UKDM and JDM.

Ted · Post by **Ted** » Sun Oct 28, 2012 9:06 pm

i have a ukdm and jdm engine at the garage what have i missed that you want to know?

Post by **NafemanNathan** » Sun Oct 28, 2012 9:09 pm

I was just wondering if maybe the spade connection one belongs to a UKDM and the small screw fixing with the ring terminal belongs to JDM motors.

Ted · Post by **Ted** » Sun Oct 28, 2012 9:10 pm

i'll check mine in the morning now stop trolling this forum tonight and get back to work

Post by **NafemanNathan** » Sun Oct 28, 2012 9:15 pm