1992 bb1 h22a si-vtec jdm import-updated 31/5/16

GJMHONDA2012 · Post by **GJMHONDA2012** » Thu Jan 07, 2016 1:18 am

New front upper balljoints fitted just need to replace the front anti roll bar links which are sat in the house

GJMHONDA2012 · Post by **GJMHONDA2012** » Thu Jan 07, 2016 1:28 am

Might sound like a stupid question but have I fitted the wishbones on the correct sides

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Thu Jan 07, 2016 8:20 am

Were they the same way round as the ones you took off?

GJMHONDA2012 · Post by **GJMHONDA2012** » Thu Jan 07, 2016 8:38 am

wurlycorner wrote:Were they the same way round as the ones you took off?

i can't remember mate they were off the car for around a week or so to replace balljoints but it's been goin round my head over and over again wondering if they are on the correct sides, I've tried to look at pictures from Google to confirm it but still don't know haha there's no wierd knocking or strange noises

mercutio · Post by **mercutio** » Thu Jan 07, 2016 5:29 pm

if you havnt the upright will be angled back so should be easy to tell and they have right and left stamped on them

GJMHONDA2012 · Post by **GJMHONDA2012** » Thu Jan 07, 2016 5:34 pm

mercutio wrote:if you havnt the upright will be angled back so should be easy to tell and they have right and left stamped on them

ill check tomorrow for left or right marks but I did check them and couldn't see anything

89 UKDM BA4 4WS (resto job!) · Post by **wurlycorner** » Thu Jan 07, 2016 6:39 pm

And also...

left and right viewed from where?

mercutio · Post by **mercutio** » Thu Jan 07, 2016 9:35 pm

wurlycorner wrote:And also... left and right viewed from where?

dont start that again just make sure the l+r match the l+r on the track rods

GJMHONDA2012 · Post by **GJMHONDA2012** » Fri Jan 08, 2016 4:06 pm

Well that's the rear 2ws subframe fitted there is still some little bits to do ie 4ws wiring loom and Ecu to be removed but I must say it feels so much better to drive a lot stiffer being polybushed pics to follow in next couple days

GJMHONDA2012 · Post by **GJMHONDA2012** » Thu Jan 14, 2016 5:22 pm

New quick release wheel boss kit fitted

Lude Generation

1992 bb1 h22a si-vtec jdm import-updated 31/5/16

Re: 1992 bb1 si-vtec jdm import, 2ws conversion

Re: 1992 bb1 si-vtec jdm import, 2ws conversion

Re: 1992 bb1 si-vtec jdm import, 2ws conversion

Re: 1992 bb1 si-vtec jdm import, 2ws conversion

Re: 1992 bb1 si-vtec jdm import, 2ws conversion

Re: 1992 bb1 si-vtec jdm import, 2ws rear subframe fitted